1 Copy
TEAC DVD Duplicator User’s Manual
13
Chapter 3. DVD Duplicator Functions
The DVD Duplicator features 12 functions: Copy, Test, Test &Copy, Verify,
Compare, Prescan, Disc Info, Select Source, Image, Edit Track, Setup, and
Advanced Setup. Each function is explained below.
1 Copy
The
Copy
function enables you to copy data from a source DVD or a partition on
the internal hard disk (if your DVD Duplicator features a factory-installed hard
disk drive). For more information, refer to “Basic Operation” on page 8.
To copy data to one of more DVD-R discs, follow the steps below:
1.
Switch to function
[1 Copy]
by pressing the
button.
2.
Insert a source disc in the source drive and a blank DVD-R disc into the
target drive.
(Note: If your DVD Duplicator features a factory-installed hard disk drive
and you wish to copy data from a partition on the hard disk, refer to “Loading
Data to and Copying from the Hard Disk Source Drive” on page 9.)
3.
Press the
(ENT)
button.
When the copy operation is complete, the target drive ejects the copied disc.
4.
To make additional copies of the same source disc, insert another blank
DVD-R disc into the target drive and press the
(ENT)
button.
Otherwise, press
(ESC)
to return to the main menu.
2 Test
The
Test
function simulates writing to the target disc. Discs will remain blank
after the test is complete. This function is recommended if you are using
unsupported media. This function enables the target drive to adjust its laser to the
proper intensity.
Note:
You can use DVD-RW discs that already contain data (i.e., DVD-RW discs
that are not fully blank) as target discs. However, the data stored on the DVD-
RW disc will be erased automatically before the new data is copied. No special
setting or procedure is required to erase the old data.
TEACdvwd11.book Page 13 Sunday, May 1, 2005 6:04 PM