Teac Esoteric SZ-1, Owner'S Manual

10

Battery Replacement

If the distance required between the remote control unit and
main unit decreases, the batteries are exhausted. In this case
replace the batteries with new ones.

Precautions concerning batteries

<

Be sure to insert the batteries with correct positive “

+

” and

negative “

_

” polarities.

<

Use batteries of the same type. Never use different types of
batteries together.

<

Rechargeable or non-rechargeable batteries can be used but
not mixed together. Refer to the precautions on their labels.

<

When the remote control unit is not to be used for a long
time (more than a month), remove the batteries from the
remote control unit to prevent them from leaking. If they
leak, wipe away the liquid inside the battery compartment
and replace the batteries with new ones.

<

Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.

Notes on use

<

Point the remote control unit at the player’s remote sensor
within seven meters (23 feet) of the player. There should not
be any obstacles between the player and the remote control
unit.

<

Do not allow direct sun or other light to shine on the remote
sensor part of the player. This may cause the remote control
unit to work incorrectly.

<

Note that other units with remote controls may operate
incorrectly because of infrared light “overspill” when you
operate this remote control unit. 

How to insert the batteries

Remove the cover of the remote control unit with a
screwdriver. After checking the polarity (

+

/

_

) of two AA

batteries, insert the batteries, replace the cover and replace
the screws.

<

Take care not to pinch cables with the battery case.

Remote Control Unit

Restoring factory settings

If you have made a lot of changes to the setup, and want to
restart from a known set of options, restore the unit to the
factory settings as follows:

1. Unplug the power cord from the outlet.

2. While holding down the 

L

/

H

button, plug the power cord

into the outlet.

All memories are erased, and the unit returns to the factory
settings.