– 9 –
ENGLISH
IP Configuration Page (see figure 4)
IP Config
Function
Description
Automatic IP
Receive network address automatically or activate as DHCP Server
Static IP as below
Set network address manually. IP, Subnet Mask, Gateway, DNS
Maintenance page (see figure 5)
Firmware Upload
If you want to update a new firmware, please press
Browse
button and select it; then press
Upload
to continue. Wait a few seconds to complete the procedure. It will show
update successful and reboot is required.
System Reboot
Press
Reboot
button to reboot the system.
Factory Defaults
In case you want to restore to default setting press
Reset
button.
SMB Server Page (see figure 6)
Folder List
Here you can
Create
,
Rename
or
Delete
different folders to be appear as shared folders on the LAN. Please select the folder and press
-->
to transfer to the
Sharing List.
Sharing List
If you want to set Password to the shared folder, please select the desired folder and press
Password.
FTP Server Page (see figure 7)
FTP Configuration
Function
Description
FTP Status
You can enable or disable FTP server service.
Allow anonymous?
You can enable guest account to let anyone to access to LanDisk
Read only
Set the guest account to read permission only
Read/Write
Set the guest account permission to read and write
Home Directory
The shared folder used for guest account
Account List
You can create different user’s account and set its permission level.
Function
Description
Username:
User’s login name
Password:
User’s login password
Access
Read only or Read/Write permission
En/Disable
Enable or Disable user’s account
Disk Utility Page (see figure 8)
Disk Utility
Function
Description
Format Disk
Initialize the hard disk to be used for the first time.
Scan Disk
Scan hard disk for lost clusters and fix them.
USB Mode
System Requirements
An available USB port (USB version 1.1 or 2.0), Windows 98SE/Me/2000/XP or later, Mac OS 9, X or later
Installation
Turn off the power to your USB hard drive (power switch
). Turn on the power to your computer. Insert the power cable plug into the input connector
on the rear panel
of the USB hard drive. Plug the other end of the power cable into an AC outlet.
Important: Please use a wall outlet which is easily accessible and located near the
unit.
Connect the wider plug of the included USB 2.0 cable to a USB port on your computer. Connect the other end of the USB 2.0 cable to the USB 2.0 port
on the rear
panel of the USB hard drive. Turn on the power switch
on the USB hard drive. Confirm that the Power LED
on the USB hard drive lights up.
Driver
Windows
: There is no need to install drivers for your TEAC HD-35PUK (with the exception of Windows98SE). As a plug-and-play device it is recognized automatically.
Macintosh
: The Macintosh automatically detects the USB hard drive and displays the icon for the USB hard drive on your Macintosh desktop.
Disconnecting the USB Hard Drive from a Computer
Windows
: Left-click on the Hardware disconnecting icon
on the Taskbar at the lower right of the screen. Left-click on the applicable drive.The message that the USB
storage device can be safely disconnected appears in a few seconds to allow you to remove the USB cable connecting the drive and the computer. Click the OK button to
pull out the USB cable.
Macintosh
: Drag the icon for the USB hard drive to the Trash icon on the Macintosh desktop. You may now safely disconnect the USB hard drive from your computer.
Safety Precautions
To prevent fire or shock, do not expose the unit to moisture or rain.
To prevent electrical shock, do not attempt to disassemble the hard drive. Refer servicing to authorized personnel.
