42
ENGLISH
Trouble Shooting
In case of trouble with the unit, please take the trouble to look
through this chart and see if you can solve the problem yourself
before you call your dealer or TEAC service center.
Amplifier
No power
e
Check the connection to the AC power supply.
No sound from speakers.
e
Check the connection to the speakers.
e
Adjust the volume.
e
Select proper source.
e
Pull out the headphones’ plug from PHONES jack.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar appliances.
Install the unit apart from them, or turn them off.
Tuner
Cannot listen to any station, or signal is too weak.
e
Tune in the station properly.
e
If a TV is near the unit, put it off.
e
Install the antenna again after locating the best reception
position.
e
An external antenna is recommended.
Though the broadcast is stereo, it sounds monaural.
e
Press the MONO button.
CD Player
Cannot play.
e
Load a disc with label side up.
e
If the disc is dirty, clean the surface of the disc.
One track is played repeatedly.
e
Press the REPEAT button to cancel the repeat mode.
Sound skips.
e
Place the unit on a stable place to avoid vibration and
shock.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
No program playback.
e
Press program button to display "PROGRAM".
e
Press play button to start playing.
Remote Control Unit
Remote control doesn’t work.
e
If the batteries are exhausted, change the batteries.
e
Use remote control unit within the range (5m/15ft) and
point at the front panel.
e
Clear obstacles between the remote control unit and the
main unit.
e
If a fluorescent light is near the unit, put it off.
