Troubleshooting (1)
If you experience any problems with this unit, please take the time to read through these pages and see if you can solve the problem yourself
before you call your dealer or a TEAC service center.
Moreover, the problem might be caused by something other than this unit. Confirm that connected devices are also being used properly.
Erratic behavior of the unit during video/audio playback
Make sure that the file being played uses one of the formats shown on page 31 "Specifications".
o
Install the latest operating system version on the iPod/iPhone.
o
If the problem continues to occur, put the unit into standby and then on by pressing the STANDBY/ON (
o
¤
) button.
Then, make sure that the above two conditions are met.
No sound output via dock connection during video playback
Play video via AirPlay.
o
Symptom
Possible cause
Remedy
No power
The AC input cord is disconnected.
Connect the cord securely.
Poor connection at AC wall outlet or the outlet
is dead or off.
Check the outlet using a lamp or another
appliance.
No sound
The master volume is adjusted too low.
Adjust the master volume.
The MUTE button is pressed to “ON“.
Press the MUTE button to cancel the muting
effect.
Incorrect selection of input source.
Select the desired input source correctly.
Incorrect connections between the components.
Make connections correctly.
Remote control does
not operate
No battery is inserted or the battery is exhausted.
Insert or replace the battery.
The remote sensor is obstructed.
Remove the obstacle.
Stations cannot be
received
No antenna is connected.
Connect an antenna.
The desired station frequency is not tuned in.
Tune in the desired station frequency.
Antenna is in wrong position.
Move antenna and retry tuning.
Preset stations cannot
be received
An incorrect station frequency has been
memorized.
Memorize the correct station frequency.
The memorized stations are cleared.
Memorize the stations again.
Poor FM reception
No antenna is connected.
Connect an antenna.
The antenna is not positioned for the best
reception.
Change the position of the antenna.
Cannot connec t to
network
No LAN/ETHERNET cable is connected.
Connect a LAN/ETHERNET cable.
No available wireless connection.
Check for available wireless connection.
Network down.
Check that network is working.
Insufficient signal strength (wireless connection).
Shorten the distance from the wireless
LAN’s access point or remove any obstacles.
Internet radio broadcast
cannot be played
Network is disconnected.
Check the connection status.
Program is broadcasting in non-compatible
format.
Only Internet radio programs in MP3, WMA,
WAV and AAC formats can be played in this
receiver.
Internet radio station is not currently broadcasting.
Tune in a radio station that is currently
broadcasting.
Continued on the next page
29
ENGLISH
