EN
3
V
Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading to
fire, injury or the staining of nearby things. Please read and observe
the following precautions carefully.
o
Be sure to insert the batteries with correct positive (
¥
) and
negative (
^
) orientations.
o
Use batteries of the same type. Never use different types of bat-
teries together.
o
If the remote control is not used for a long time (more than a
month), remove the batteries to prevent them from leaking.
o
If the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
o
Do not use batteries of types other than those specified. Do not
mix new batteries with old ones or use different types of batter-
ies together.
o
Do not heat or disassemble batteries. Never throw batteries into
fire or water.
o
Do not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
o
Never recharge a battery unless it is confirmed to be a recharge-
able type.
o
Do not expose batteries to extremely low air pressure as it could
result in an explosion or leakage of flammable liquids or gases.
Laser information
This laser product is a consumer laser product according to
EN 50689:2021 and complies with all consumer laser product
requirements except child appealing products.
This product contains a laser system and is classified as a CLASS 1
LASER PRODUCT according to IEC 60825-1:2014. This class does not
require special attention in normal use. Do not take apart to prevent
being exposed to the laser beam.
Laser:
Type:
EP-C101
Manufacturer:
EVER BRIGHT ELECTRIC SCIENCE &
TECHNOLOGY(BEIHAI)LTD.
Laser output:
0.7 mW on the objective lens
Wavelength:
790 ±25 nm
Model for USA
This product has been designed and manufactured according to
FDA regulations “title 21, CFR, chapter 1, subchapter J, based on the
Radiation Control for Health and Safety Act of 1968”, and is classi-
fied as class
!
laser product. There is not hazardous invisible laser
radiation during operation because invisible laser radiation emit-
ted inside of this product is completely confined in the protective
housings.
The label required in this regulation is as follows:
