48
ENGLISH
Troubleshooting
If you experience any problems with the unit, please
take a moment to look through this chart and see if
you can solve the problem yourself before you call
your dealer or a TEAC service center.
General
No power
e
Check the connection to the AC power source.
Check and make sure the AC source is not a
switched outlet and if it is, the switch is turned
on. Make sure there is power to the AC outlet by
plugging another item such as a lamp or fan.
No sound.
e
Adjust the volume.
e
If muting is on, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV set or similar
appliances. Install the unit further from them, or
turn them off.
Tuner
Cannot listen to any station, or signal is too
weak.
e
Tune in the station properly.
e
If a TV is near the unit, turn it off.
e
Rotate the unit or antenna wire for the best
reception position.
CD Player
Will not play.
e
Load a disc with the playback side facing down.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
e
Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs may
not be playable.
e
Copy-prohibited discs may not be playable.
Sound skips.
e
Place the unit on a stable surface to avoid
vibration and shock.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
Remote Control Unit
Remote control doesn’t work.
e
If the batteries are exhausted, change the
batteries.
e
Use remote control unit within the range
(5m/15ft) and point at the front panel.
e
Clear obstacles between the remote control unit
and the main unit.
e
If a fluorescent light is near the unit, put it off.
RESET Switch
In the following cases, function buttons may not
work properly.
• When the system is damaged by some electrical
shock.
• When the power is irregular or has electrical
noise.
In these cases, press the RESET switch once or twice
lightly with a pencil or a ball-point pen.
Beware of condensation
When the unit (or a disc) is moved from a cold to a
warm place, or used after a sudden temperature
change, there is the danger of condensation; vapor
in the air could condense on the internal
mechanism, making correct operation erratic or
impossible. To prevent this, or if this occurs, leave
the unit for one or two hours with the power
turned on. The unit will stabilize at the temperature
of its surroundings.
Maintenance
If the surface of the unit gets dirty, wipe with a soft
cloth or use a diluted mild liquid soap. Be sure to
remove any excess liquid completely. Do not use
thinner, benzine or alcohol as they may damage
the surface of the unit. Allow the surface of the
unit to dry completely before using.
