How to connect a coaxial cable to the matching
transformer
1
Strip the cable and dress it as shown.
2
Press both side tabs outward to remove the
cover.
3
Wrap the core conductor around the central
metal fixture as shown. Crimp the jagged
metal fixtures so they hold the braided portion
using pliers, etc. Put the cover back in place.
_ 6 _
AM Indoor Loop Antenna
A high-performance AM loop antenna provided with the
T-R460 is sufficient for good reception in most areas.
Connect the loop antenna's wires to the AM antenna
terminals as shown. To connect antenna wires to the
terminals, loosen the terminal screw, place the lug
under the terminal then tighten the screw firmly.
Place the antenna on a shelf, for example, or hang it on
a window frame, etc., in the direction which gives the
best reception, as far away as possible from the entire
system, speaker cords and the power cord, to prevent
unwanted noise.
AM Outdoor Antenna
If the AM loop antenna provided does not deliver
sufficient reception (because you are too far from the
transmitter or in a concrete building, etc.), it may be
necessary to use an outdoor AM antenna. Use an
insulated wire more than 15 ft (5 m) long, strip one end,
and connect this to the terminal as shown. The antenna
wire should be strung outdoors or indoors near a
window. For better reception, connect the GND terminal
to a reliable ground.
Note: Even when using an outdoor AM antenna, do not
disconnect the AM loop antenna.
AM (MW) ANTENNA
AM Outdoor
Antenna
Europe Model
U.S.A./Canada/
General Export
Model
AM Loop Antenna
(provided)
Insert into slit.
Jagged metal
Jagged metal
4mm
7mm
3mm
CONNECTIONS
