8
Changing the cartridge
To change the cartridge, first remove the headshell from
the tone arm.
o
We recommend that you keep the cartridge needle
protective cap on while changing the cartridge.
Headshell
Cartridge
Shell leads
Screws
Nuts
1
Disconnect the shell lead terminals
from the cartridge.
2
Loosen the screws and remove the
cartridge.
3
Attach the new cartridge and tighten
the screws.
See the illustration below for the position of the
screws when attached.
2.0 ± 0.5 mm
4
Connect the shell lead terminals to the
cartridge.
o
The signals and colors of the shell leads are
shown below.
Signal
Color
Left c
White
Left channel −
Blue
Right c
Red
Right channel −
Green
5
Balance the tone arm and adjust the
stylus pressure.
Follow the procedures in “Balancing the tone arm
and adjusting the stylus pressure” on page 5.
Basic operation
Playing records
1
Press the STANDBY/ON button on the
back of the unit to turn it on.
2
Open the turntable cover slowly.
V
Be careful not to pinch your hand, for exam-
ple, when opening and closing the turntable
cover.
3
Place a record on the turntable.
When playing a 45 RPM large-hole single record,
use the included adapter.
4
Set according to the rotation speed
(RPM) of the record.
The rotation speed can be set to 33 1/3 or 45 RPM.
5
Turn the START/STOP rotation knob to
START to start the turntable.
o
When the START/STOP rotation knob is set to
START, the turntable will start rotating and the
blue LED will light.
6
Move the tone arm clasp to the right to
release the tone arm.
Clasp
A
N
T I
– S K A T IN
G
3
0
Summary of Contents for TN-200
Page 59: ...59 ...
