5
EN
G
LI
SH
Balancing the tone arm and adjusting
the stylus pressure
A
N
T I
– S K A T IN
G
3
0
Anti-skating
Cue lever
Counterweight
Stylus pressure adjustment ring
Center line
1
Set the anti-skating dial to zero.
2
Move the tone arm clasp to the right to
release the tone arm.
Clasp
A
N
T I
– S K A T IN
G
3
0
3
Lift the cue lever and shift the tone
arm to the left slightly.
4
Lower the cue lever.
5
Turn the counterweight and adjust so
that the tone arm is level.
A
N
T I
– S K A T IN
G
3
0
o
Remove the cartridge stylus protection cover
before making adjustments.
o
Be careful not to let the cartridge stylus touch
the unit.
6
Return the tone arm to its original
position, and move the tone arm clasp
to the left to lock it in place.
7
Turn the stylus pressure adjustment
ring so that the center line aligns with
0 on the scale.
A
N
T I
– S K A T IN
G
3
0
o
Be careful not to let the counterweight turn.
8
Turn the counterweight so that the
stylus pressure adjustment ring scale
matches the stylus pressure specified
for the cartridge.
o
The stylus pressure of the included cartridge is
2.0 g.
So, turn it to 2 on the counterweight scale when
using the included cartridge.
A
N
T I
– S K A T IN
G
3
0
9
Adjust the anti-skating dial.
Start with it set at 2 and adjust it during record play-
back (page 8) to the position where the left and
right volumes are balanced.
A N
T I – S K A T
IN
G
3
0
Notes about record styluses
o
Record styluses are precision parts, so handle them
carefully to avoid bending or damaging their tips. If
a stylus becomes bent or damaged, it might not be
able to follow the audio groove precisely and could
damage records or cause other malfunction.
o
If a stylus becomes dirty, use a commercially avail-
able stylus cleaner or similar product to clean it.
o
Do not rub the stylus tip forcefully with anything
hard. Do not wipe the stylus with thinner or other
chemicals. Doing so could harm it.
Replacing the stylus
The included cartridge is an Audio-Technica AT95E.
Purchase a replacement stylus for the AT95E cartridge
at the retailer where you purchased this unit, for
example.
Follow the replacement instructions in the manual of
the replacement stylus.
CAUTION
o
Since loud noises could suddenly occur, put the unit
into standby before changing the stylus.
o
Be careful not to hurt your hand or the equipment.
o
Be careful not to allow small children to accidentally
swallow styluses.
Summary of Contents for TN-200
Page 59: ...59 ...
