Presetting stations
Manually presetting stations:
Press the MEMORY button on the front panel or on the remote control.
The station code will blink in the display. Then, turn the TUNING knob
clockwise to select a higher station code or counterclockwise to select
a lower station code.
Alternatively, press either PRESET
j
or
k
button (
.
or
/
) to select
the desired station code. Then, press the MEMORY button on the front
panel or on the remote control. The station has been stored in your unit.
When the number is less than 10, press the number directly.
o
If you do not press other buttons, wait for 1 or 2 seconds, and then
the display shows the selected number.
Alternatively, press the “0” button first, and then press a number.
o
When the number is bigger than or equal to 10, press the number
o
directly.
Automatically presetting stations:
Press and hold down the MEMORY button on the front panel on the
remote control.
FM tuning frequencies run from FM87.50 to 108.00 MHz, and AM
tuning frequencies run from 522 to 1620 KHz .
This function enables this unit to automatically tune into FM and
o
AM stations with strong signals, and can store up to 80 of those
stations.
Selecting preset stations
Press the MODE button on the front panel or remote control. The
station's preset number will blink in the display. Then, turn the TUNING
knob clockwise to select a higher preset number or counterclockwise
to select a lower preset number.
Alternatively, press either PRESET
j
or
k
button (
.
or
/
) to
select the desired preset number. When the desired station has been
selected, press the MODE button again.
You can also select a preset station by pressing the corresponding
number buttons on the remote control.
When the number is less than 10, press the number button directly.
o
If you do not press other button, wait for 1 or 2 seconds, then the
pressed number is shown on the display.
Alternatively, press 0 button first, and then press a number button.
o
When the number is bigger than or equal to 10, press the number
buttons directly.
You can also press the PRESET
o
j
or
k
button (
.
or
/
) to
review the preset radio stations.
You can select up to 80 preset stations.
o
Basic Operation (2)
Mute
To mute the sound temporarily, press the MUTE button on the remote
control. “MUTE” will appear in the display. Press the MUTE button
again to restore the sound.
RDS
Press the RDS button on the remote control to cycle the display
throug the Time mode, PS mode, PTY mode and RT mode.
RDS stations are automatically detected.
If no RDS stations are found with the above operation, either -- : -- /
o
NO PS / NO PTY / NO RT will be shown in the display.
When an RDS is found, the time information, station's name, station
o
program type, and Radio Text (no more than 64 characters) would
appear in the display.
Display brightness adjustment
Press the RDS button on the remote control to adjust the brightness of
characters in the display based on the brightness of the surrounding
environment.
If you hold down the RDS button for 2 or 3 seconds, the display
brightness selection will toggle through “HIGH, LOW and OFF”.
The unit automatically defaults to “HIGH” brightness at startup.
o
10
