47
Enabling these inputs will use the following number of
channels.
CAN: 2 channels
GPS: 1 channel
Pulse: 1 channel
10-2-1. Monitor settings
Monitor channel
Sets the channel output through the EARPHONE jack.
Nothing will be output when set to OFF.
o
Nothing will be output when an unrecorded chan-
nel is selected.
Output level
Set the earphone jack output level.
ATTENTION
o
When recording starts, for example, output might be
interrupted momentarily.
o
Voice memos will not be output when record ready
or recording.
10-2-2. Channel settings
Make input amplification settings for each channel.
o
Use the buttons on the right side of the screen to
select the channel to set.
Range
Sets the input amplification range. Set the range to a
voltage value that the analog signal will not exceed.
Mode
DC:
DC mode
AC:
AC mode
ICP:
ICP mode
Select this when using an ICP sensor. 24V
4mA power will be supplied.
HPF
Sets the high pass filter.
Select OFF to disable the high pass filter.
LPF
Sets the low pass filter.
Select OFF to disable the low pass filter.
Channel name
Sets the name of the channel.
o
A maximum of 20 characters can be used for a
channel name.
o
See “9-4. Inputting characters as setting values” on
page 39 for how to input characters.
10. SYSTEM settings
Summary of Contents for VR-24
Page 1: ...Analog Visual Recorder Owner s Manual Z VR 24 D01255010D...
Page 67: ...67 15 Exterior drawings 260 77 12 5 186 Unit mm...
Page 70: ...70...
Page 71: ...71...
