27
At all other times,
this shows the amount of space used on the current
media.
q
Bar meters
6-6. Data display
When this unit is record ready, recording or playing
back, you can choose whether its display shows video,
graphed waveforms of analog data or bar meters.
6-6-1. Video display
Use the camera input switching buttons to select the
video you want to show on the display. The display will
show the selected data from CAMERA-1 or CAMERA-2.
The display cannot show both images at the same time.
Exposure adjustment buttons
White balance button
Camera button
o
The buttons shown depend on the settings made in
SYSTEM
w
Camera.
Camera button
When record ready or recording, readjusts the exposure.
White balance button
When record ready or recording, readjusts the white
balance.
Exposure adjustment buttons
Usually the brightness will be adjusted so that it is
optimal, but you can touch the + button to intention-
ally make it brighter.
6. Basic operation
You can touch the – button to intentionally make it
darker.
The adjustment range is ±2.
o
Since the range of adjustment is limited, using the
exposure adjustment buttons might not change
the brightness.
6-6-2. Graphed analog data waveform
display
Touch the graphed waveform display button to show
graphed waveforms of analog data on the display.
Waveforms will not be shown for channels that have
their input settings OFF. Moreover, their data, including
channel numbers on the left side, will not be shown.
Graphed waveforms can be shown for a maximum of
four channels at the same time, Moreover, it is not pos-
sible to designate which channels are shown.
Summary of Contents for VR-24
Page 1: ...Analog Visual Recorder Owner s Manual Z VR 24 D01255010D...
Page 67: ...67 15 Exterior drawings 260 77 12 5 186 Unit mm...
Page 70: ...70...
Page 71: ...71...
