8.10 UPGRADE:
firmware (F/W) upgrade.
●
Download the new firmware from
www.teac.de
and copy to an USB disc.
●
Plug the USB disk to SMR USB port. Wait until the USB symbol appears.
●
Switch to Settings and choose
UPGRADE
. The UPGRADE screen appears.
Available options by the center softbutton
(3)
:
1.
System Upgrade
2.
Reboot System
3.
Reset To Factory Default
●
Scroll to “System Upgrade” from option list, confirmed by
OK (7)
button and
it will bring up file selection screen.
●
Use UP/DOWN keys to scroll the file list. You can check
F/W version
and
F/W build
by the center softbutton
(3)
.
●
Press
OK
on F/W file. Now the system will check if this file is OK to upgrade
and then bring up a warning message.
●
Use
LEFT (8)
key to move cursor to “Yes” and press OK if you are sure to
upgrade. Now the WAP-4500 system will start upgrade procedure.
After the progress bar goes to 100%, system will reboot. After apprx. 30 seconds,
the system will display F/W screen again with the new F/W data.
24
ATTENTION:
During the firmware upgrade, there
must be
no interruption
of the power supply! The
USB device
from which the firmware is
downloaded
must not be disconnected
during the
whole firmware upgrade procedure!
Summary of Contents for WAP-4500
