20
K
MONITOR OUT connector
This can be used to output a monitor signal, which can be the
input signal of any channel or the voice memos.
L
SDHC card slot
Insert SDHC cards here. (See page 30.)
M
RDX cartridge emergency ejection hole
Use if you cannot eject the RDX cartridge with the EJECT but-
ton. (See page 29.)
N
RDX cartridge dock
Load RDX cartridges here. (See page 29.)
O
RDX cartridge EJECT button and indicator
Use to eject RDX cartridges. (See page 29.)
The indicator shows the status as follows.
Indicator
Meaning
Explanation
Unlit
No power
No power is being supplied to
the RDX docking station.
Lit green
Ready
Power is being supplied to the
RDX docking station and it is
functioning properly.
Blinking
green
Ejecting
The cartridge is being ejected
from the docking station.
Lit yellow
Malfunctioning
A malfunction has been
detected in the RDX docking
station.
Blinking
yellow
Ready
The RDX media was being
accessed when you pressed
the EJECT button. After blink-
ing yellow for a few seconds,
it will light green.
P
LEVEL LEDs
Each LED lights green when its input level exceeds 10% of
its input range and lights red when it exceeds 115%. When
using an ICP sensor, the LED lights yellow when there is no ICP
current.
4. Names and functions of parts
Q
Input connectors
Use these to input measurement signals.
Summary of Contents for WX-7000
Page 1: ...WIDE BAND DATA RECORDER Owner s Manual Z WX 7000 D01190210J ...
Page 84: ...84 19 Exterior drawings WX 7016 340 348 10 8 220 13 8 123 82 40 15 WX 7032 164 82 40 40 15 ...
Page 85: ...85 WX 7064 246 82 40 40 40 40 15 WX 7096 360 370 396 19 Exterior drawings ...
