42
9. Playback
9-7. Searching by time
When ready for playback, select the date and time (TIME), and search
for the desired date and time. Then, press the VALUE knob to start
playback from the position of that date and time.
o
After selecting the date and time (TIME), press the VALUE knob to
make the date and time display larger.
9-8. Continuously playing back
long recordings
Note about units with program versions older than MAIN
FIRM V1.11
When continuously playing back long recordings that use data in
multiple files, continuous playback will be interrupted for a few sec-
onds when files change.
Playback time
Aaa001.dat
(4GB)
Aaa003.dat
(<4GB)
Aaa002.dat
(4GB)
Playback starts Search for file
Search for file
Playback stops
10. Synchronization function
10-1. Connections
Master unit
Slave unit
Synchronization cable
o
Use a synchronization cable to connect the master unit SYNC OUT to
the slave unit SYNC IN.
o
When not using synchronized operation, do not connect the syn-
chronization cable.
o
Always turn the master unit and slave unit off before connecting
or disconnecting a synchronization cable.
10-2. Turn the units on
In order, turn on the slave unit and then the master unit. When the
master unit starts up, it will automatically check the connection.
If the master unit is turned on before the slave unit, an error will
occur during the connection check. In this case, conduct the con-
nection check manually.
o
The clock times of the master unit and slave unit will not be
synchronized automatically. Set the time on the master unit
SYNCHRO SETTING screen .
Summary of Contents for WX-7000
Page 1: ...WIDE BAND DATA RECORDER Owner s Manual Z WX 7000 D01190210J ...
Page 84: ...84 19 Exterior drawings WX 7016 340 348 10 8 220 13 8 123 82 40 15 WX 7032 164 82 40 40 15 ...
Page 85: ...85 WX 7064 246 82 40 40 40 40 15 WX 7096 360 370 396 19 Exterior drawings ...
