36
5.6.
Reading and preservation of a setup
A setup of a system, each channel, and a trigger can be saved as a "parameter file." The following
window will be displayed if "reading and preservation of a parameter" are chosen from a menu or
a tool bar.
When this window is opened, a setup of present WX-7000 is displayed. When a "setting
preservation" button is pushed, especially operation changes operation by selection of a "reading
and preservation place" group as follows. Please be careful.
button
target
"Parameter reading" button
"Parameter preservation" button
RDX in WX-7000
or
SD in WX-7000
A parameter file is read from RDX
or SD in a WX-7000 recording unit,
and the contents are displayed on
a window.
The system, trigger and each channel
of present WX-7000 are saved as a
parameter file to RDX or SD in a
WX-7000 recording unit.
Files in PC
A parameter file is read from the
memory media of PC, and the
contents are displayed on a
window.
The contents which the present
window shows are saved as a
parameter file to the memory media
of PC.
When a "parameter reading" button is pushed, the contents of a display of a window change, but
in this stage, the command of setting change has not been transmitted to WX-7000 yet. A push
on the OK button will actually change a setup of WX-7000 as below-mentioned.
System Settings
Channel Parameter List
Trigger Settings
