Page 8
Setup
Getting Started
Unpack Teach Me Time! and discard the paper LCD label by
removing the colored bezel (see below). Plug the external AC
adapter into the back of the product. Next plug the AC adapter
into a standard wall outlet.
Changing the Colored Bezel
Change the bezel by gently turning counter-clockwise until it
stops. Pull the bezel away from the clock to remove. Install a
new bezel and turn it clockwise until it locks in place.
Setting the Time
The first time you plug in Teach Me Time! you must set the time:
1.
Press and hold the SET key for two (2) seconds to enter
set time mode.
The numeric portion of the display
flashes and the word “SET” appears.
2.
Adjust the time using the HR +/- and MIN +/- keys. Press
and hold these keys for one (1) second to scroll rapidly.
3.
Tap the SET key once quickly to exit.
Battery Backup (Optional)
Teach Me Time! may be used with two AAA batteries (not
included) to save settings in the event of a power failure. To
insert the batteries, remove the screw from the battery hatch
(bottom of unit) using a small screwdriver. If the hatch does not
fall open freely, use your fingernail or a paperclip to gently
dislodge it.
NOTE: Many functions of Teach Me Time! still work under
backup battery power. However, to conserve battery life, the
night-light and display backlight features do not function.
NOTE: If the battery level is very low Teach Me Time! may not
have enough power to clearly announce the time or may
become unresponsive. In this event, please replace the
batteries with a fresh set.
TIP
: The rear hatch
conceals the parental
controls and is designed to
be “child proof.”
To open the hatch, place
your thumb on the latch
and gently push down and
back. You may flex the
cover slightly to facilitate
opening the hatch:
Do not attempt to open
the hatch by using a
fingernail to pull in an
upward direction as this
may break the latch
mechanism.
Summary of Contents for TMT081-US
Page 2: ......
Page 7: ...Page 7 ...
