Need to know: The free end of the rope coming out of the brake is two ropes that are looped at the end. Each
rope can be individually adjusted to straighten the object you are lifting when first setting it, but most of the
time you will pull both of them together and treat it as a single rope.
Assemble straps and operate hoist
To set the brake to prevent the hoist from lowering, move the free rope end in a straight line
toward the direction the rope comes out of the brake pulley.
1
To attach your object, place it below the hoist and use the
rope and brake to set the Strap Brackets (C & D) to a height
just above the object. Place the Straps (G) underneath the
object you are storing so that the ends come over the top
and align them under the Strap Brackets.
3
4
Orient the Strap so that the buckle is facing up and the strap is
not twisted. Weave each Strap end through the cutouts in the
bottom of the Strap Brackets
To release the brake and lower your object, grab the rope tightly and prepare to hold the weight
of your object. Pull straight down on the free end of the rope until the brake releases and raise
the rope toward the ceiling to lower your object.
2
Pull away and release to lock
Hold tightly and pull down to unlock
