Assemble rope and strap brackets
Overview of Parts and Rope Steps
Place the Strap Brackets (C & D) on the floor below the Pulley Ceiling Plates and orient them so the
cross straps face each other. To make sure they don’t turn while installing the rope, connect the
cross strap on the Strap Bracket C through the buckle on the Strap Bracket D and tighten to remove
the slack
Before you install the rope, note
this image. On Steps 5.3 and 5.9,
you have to make sure you are
passing the rope over the
correct pulley
L
B
1
From the starting knot, pull the rope through your hands to make sure it is smooth and loosely
coil it on the ground.
4
The Double Pulley Plate (L) and Brake Pulley Plate
(B) each have two pulleys, and the Brake Pulley
Plate (B) has two brake holes.
"Pulley 2" and "Brake Hole 2" align with the knot
hole.
"Pulley 1" and "Brake Hole 1" do not align with the
knot hole.
2
To install the rope, start at the knot hole on the Single Pulley
Plate (A). Place the end of the rope through the knot hole and
loop a few inches around the rest of the rope and tie a basic
knot. Pull down gently on the remaining rope to tighten the
knot.
3
A
B
L
C
D
1
2
3
4
5
6
7
8
9
10
11
Starting
Knot
Pulley 2
Knot Hole
Pulley 1
Pulley 2
Pulley 1
Brake Hole 2
Brake Hole 1
