Across to Double Pulley Plate (L) and over the top of Pulley 1 (the pulley NOT aligned with the
knot hole on the bent tab)
Across to Brake Pulley Ceiling Plate (B) and over the top of Pulley 1
Through Brake Hole 1. Make sure the rope goes under the brake “teeth” as shown in Figure ##.
Pull rope coil through Brake Hole 1 until Strap Bracket 1 (C) is about to lift off the ground.
Loosely coil the rest of the rope on the ground below the Brake Pulley Plate (B).
3.
4.
5.
6.
Down and around the pulley on Strap Bracket 1 (C) below Single Pulley Plate (A)
Up and around the pulley on Single Pulley Plate (A)
1.
2.
5
A
B
L
C
D
1
2
Starting
Knot
Steps 1 & 2
These Steps
Future Steps
Completed Steps
End of Rope is Here
A
B
L
C
D
Steps 3 - 6
1
2
3
4
5
6
Starting
Knot
