B A G H
REMOVE THESE
PARTS FOR:
Steps 1-2
6285, qty 2
4-40 x 1/4
1:1
GEAR COVER
Trim the #9247 gear cover, cutting out three
holes shown. Insert the #9247 insert button
into the large hole cut into the gear cover.
Mount the cover with two #6285 screws.
INSTALLING THE BATTERY PACK
Install the three #9235 foam battery pads.
Install the two #9238 foam battery spacers. (The tuning section will show you how to
adjust your steering or traction by moving these spacers.)
Install your battery pack. (See step 5 if you need to assemble it first.)
Thread on the #6929 screw. Aim the body clip hole across the chassis. Add the #9230
(9229*) battery hold down strap. Adjust the screw so the batteries are held tight, but you
are still able to push the #6332 body clip through the screw.
9247, qty 1
gear cover
9247, qty 1
button
9235, qty 1
foam battery pads
9238, qty 2
battery spacer
6929, qty 1
4-40 x 3/8
1:1
9230, 9229*, qty 1
battery hold down strap
6332, qty 1
body clip
SOLDERING INDIVIDUAL CELLS
Solder connections properly to assemble a
battery pack from individual cells.
TIP:
Team racers prefer battery bars or braid
for sturdier connections. Insulated wire will not
allow the pack to fit in the battery slot.
solder connections
with battery bars
or braid
BATTERY PRODUCTS ARE
NOT INCLUDED IN KIT
T O O L S U S E D
21
3/32"
s t e p 1
L E F T S I D E
s t e p 2
R I G H T S I D E
PARTS REMOVED
FOR CLARITY
9235
9238
6929
9230,
9229*
6332
hook into rear shock
tower as shown
9247
6285
