ball cups thread on in opposite directions
1:1
REMOVING BALL CUPS
Hold the cup next to the ball
with your pliers and twist the
cup off
.
9142, 9143*, qty 1
front shock tower
REMOVE SUSPENSION ARMS
Twist the #9107 (9108*) suspension arms
from the mold runners (shown in gray)
with your pliers, and trim away remaining
molding with your hobby knife. Do not cut
off the antiroll mounting balls. Carefully trim
balls so they are perfectly smooth.
ARMS TO BULKHEAD
Attach the block carrier assembly to the #9107 (9108*)
suspension arm with its #9115 hinge pin and #6299 E-clips.
Align the #9125 bulkhead with the #9107 suspension arm
hinge pin holes as shown. Install #6299 E-clip to one end of
#9110 hinge pin. Next hold the #9120 front cross brace in
front of the suspension arm while sliding the #9110 hinge
pin through the assembly. Install #6299 E-clip to other end
of pin. Assemble the other side the same way.
SHOCK TOWER TO BULKHEAD
Attach the shock screws and hardware #7413,
6936 and 6295. Do other side.
Attach the #9145 ball ends and #7260 nuts
through middle holes.
Attach the shock tower to the bulkhead with
the three #6924 screws.
Twist #7230 ball cups onto the #6263
(-
(1406*) turnbuckle until you get the
dimension shown.
Connect ball ends with the turnbuckle ball
cups as shown, using your needlenose
pliers.
7413, qty 2
4-40 x 3/4
6936, qty 2
#4 washer
6295, qty 2
4-40 nut
6924, qty 3
4-40 x 3/8
9145, qty 2
ball end
7230, qty 4
large ball cup
6263, 1406*, qty 2
2.06" turnbuckle
9110, qty 2
front inner hinge pin
9115, qty 2
front outer hinge pin
6299, qty 8
E-clip
9120, qty 1
cross brace
steel
9125, qty 1
front bulkhead
s t e p 2
L E F T S I D E
B A G A
7260, qty 2
4-40 nut
3/32"
1:1
1:1
1:1
1:1
1:1
1:1
1:1
1:1
1:1
1:1
1:1
T O O L S U S E D
COMPLETED FRONT ASSEMBLY
4
9107, 9108*, qty 2
front suspension arm
V I E W
E D F R O M R E A R
REMOVE THESE
PARTS FOR:
Step 2
9107,
9108*
9115
9125
9145
9145
6924
7230
9120
7260
6295
6936
6924
7230
9110
6299
6299
6299
7260
7413
9107, 9108*
6299
HOW TO USE THE
TURNBUCKLE WRENCH
2 3/4" (2.75" or 69.9mm)
6924
6263, 1406*
DO NOT CUT OFF BALLS.
REMOVE FLASHING SO BALLS
ARE PERFECTLY SMOOTH.
9107, 9108*
6263, 1406*
