Team Corally PYTHON C-00182, Quick Start User Manual

SILICONE

OIL

50%

WAIT

TIGHTEN

TIGHTEN

FULLY

5min

FILL

MOVE

UP

3-4x

SLOWL

Y

MOVE

UP

FRONT

REAR

SILICONE OIL

SPRING TENSION

SILICONE OIL

SPRING TENSION

SHOCK PISTON

TRACK USE

450CPS

12mm

400CPS

4mm

6 Holes Ø1.3mm

OFF-ROAD

550CPS

12mm

450CPS

4mm

6 Holes Ø1.3mm

BASHING

600CPS

12mm

500CPS

4mm

6 Holes Ø1.3mm

SPRING TENSION

10

SHOCK ABSORBER MAINTENANCE

Remove the shock absorbers from the car. (4x)

Remove the shock cap.

Drain the oil from the shock absorber. 

It may be necessary to replace the silicone oil in the shock absorbers every 40 runs.
It depends on how you drive and the type of terrain you drive on.

FILL THE SHOCK ABSORBERS WITH NEW SILICONE OIL

 ALWAYS USE SILICONE OIL, NEVER USE ANY OTHER TYPES OF OIL.

.

www. corally.com/Chemicals/Silicone-Oils/

• Pull the Shock shaft 

down.

• Fill the shock body with 

silicone oil.

• Front : 450cps 

Rear : 400cps

• Move the piston up&down 

(3-4x) to release the air 
bubbles in the silicone 
oil.

• Pull the Shock shaft 

down.

• Install the shock absorb-

er vertically and let it sit 
for a few minutes until 
the bubbles rise to the 
surface. 

• Install the silicone mem-

brane in the shock cap. 

• Tighten slightly the 

shock cap on the shock 
body.

• A little oil will flow out of 

the shock absorber.

• Gently move the piston 

in upper position.

• The excess will flow out 

of the shock absorber.

• Allow the piston in the 

upper position.

• Tighten the cap fully but 

not too much otherwise 
the membrane will be 
deformed.