Bag "R" and Bag "1"
Bag "6"
Long
Screw
Keep these 2 loose for now.
Tighten and align later when
installing side links.
Longer Screws
tighten
firmly
Install the 2 small 2-56 button
head screws - Do not over tighten.
Pivot ball must move freely.
Holes are
oversized to
allow for
adjustment.
This part
"floats" to
allow links
to be free.
From Bag "3"
From Bag "3"
Side View
Hex Pivot
Ball
Alum
cone
Bag 1 contains the graphite bottom plate,
aluminum cone, and hardware. Mount the
hex pivot balls (from Bag 2) securely by
tightening them with a 3/16" nut driver. Do
not use the screw head to tighten the hex balls.
hex nut
2 hex nuts
small ID
washers
Mounted Pivot Assembly (football shaped).
Shown here with the rear lower pod removed.
Don't forget to trim the plastic pivot ball cups
as shown above.
Installing the Rear Pod
Mount the Battery brace using these 2
holes. Stack the cones to form an "hour-
glass" shape. Then place the brace
above the cones and lock with a nut.
Bag 8
3
locknut
Small
washer
Large
Alum
washers
2 hex
nuts
Pivot
Plate
TRIM Plastic!
For Motor + Battery
Clearance
