11) Dual watch function
[
DW
]
This function allows you to monitor two channels for signals. Before activating this function
make sure that the squelch is set to
ASQ
, as described in paragraph 2).
First, select the first channel to be scanned with the rotary channel switch (8) or the Up/Down
keys (2) [
p
] and (3) [
q
]. Then, briefly press the dual watch key (12) [
DW
]. The dual watch
symbol
DW
flashes in the LCD window. Now, set the second channel to be monitored and
press the dual watch key (12) [
DW
] again. The dual watch symbol
DW
will light constantly,
which indicates that the dual watch function is activated.
Make sure that the second push on the dual watch key occurs within 23 seconds after the
first one. Otherwise, the DW function will be aborted, which will be indicated by the extinction
of the flashing dual watch symbol
DW
in the display.
12) External speaker jack
The MC-8 MarkII is equipped with a 3.5 mm jack socket (17) at the rear panel to connect an
external speaker of 4-8 ohm impedance. At 4 ohms the speaker load can be 4 watts (e.g. TEAM
TS-500). When the external speaker is connected, the internal speaker will be switched off.
13) Signal meter internal/external
An external s-meter can be connected via the 2.5 mm jack socket (18) at the rear panel of
the MC-8 MarkII
Please note that the external S-meter shows only the relative field strength of the incoming
signal.
English
English
Additional information
1) Safety instruction
Drivers must keep attention to traffic rules when using the transceiver in a vehicle. While driving.
The unit radiates RF energy in transmit mode. Please keep an eye on safety distance to the
antenna.
2) General precautions
Protect the set from humidity and dust. Do not store at places where the temperature may
rise and cause damage - do not expose to direct sunlight. The set can be cleaned by wiping
with a soft cloth. Do not use chemical products to clean the set.
3) Servicing
The device must not be opened. Independent repairs or adjustment must not be carried out,
since each modification or unauthorized intervention will cancel warranty and repair claims.
Do not use the set if it seems not to function correctly. Disconnect the set in this case from
the DC power source immediately. If there is a defect, the authorized TEAM specialist deal-
er or TEAM must be contacted in every case.
4) Conformity
The CB mobile transceiver TEAM MC-8 MarkII complies to the European directive R&TTE
and meets the European standards EN 300 135-2, EN 300 433-2, EN 301 489-1/-13 and EN
60950-1.
The specific regulations of the different versions in the different european countries can be found
in the radio passport that is included in this manual.
Specifications are subject to change without any prior notice or obligation on the part of the manufacturer.
18
19
MC-8-MarkII_manual_2:RoadCOM manual.qxd 10/17/2013 1:00 PM Seite 18
