contains also a CTCSS tone. If the unit has found one, it identifies its corresponding
code number and shows it in the display at the position ( G ). To activate the scan
function depress out of the keys ( 4 ) Down once or Up 7 times. The display
shows the writing . Then depress briefly the confirmation key ( 5 ). Then the
display shows . On the left side of the writing “UP“ you see an arrow, which
can be moved with the help of the Up/Down keys ( 4 ) either to the left side of the writ-
ing “DOWN“ or back to the left side of the writing “UP“. For the final activation of the
channel scan function put the arrow to one of both writings and then depress the con-
firmation key ( 5 ). The display returns to the main screen, but without a CTCSS code
number. According to the chosen direction the channel scan starts stepping upwards
or downwards. The unit stops on every occupied channel, where the squelch opens,
for 10 seconds. If there is in the demodulated signal also a CTCSS tone, it will show
also the corresponding CTCSS code number. 10 seconds later or after the signal has
dropped below the squelch threshold the channel scan function continues searching.
By pressing the confirmation key ( 5 ) the channel scan function is terminated and the
unit remains on the actual channel. If the unit has been on an occupied channel
where a CTCSS coded station has made a transmission, the display will take over this
CTCSS code. If the station had no CTCSS code or the channel was free, the unit
keeps the CTCSS setting which has been active before starting the channel scan.
10) Transmitting
For speech transmission depress and hold the transmit key PTT ( 9 ) on the left side
of the unit. In the display appears the symbol ( E ). If the channel scan function
English
17
T
▼
▼
Scan
on?
UP
DOWN
▼
