English
9) Power save function
The power save mode is only active in reception mode. If the squelch is not opened
by a signal for at least 20 seconds, and if there is no key entry during this time, the
unit falls into the power down mode. In this mode the receive section is supplied only
periodically for a short time, so that the current consumption goes down from 40 mA
to 15 mA. On receiving of a signal or pressing any key the power save mode swit-
ches itself off again.
10) Receipt tones
If a signal is found on the actual channel in PMR or LPD operation the receipt tones
are switched off. Otherwise every pressure of a key is indicated by a short tone.
Operation of the TEAM UHF-DualTalk
The TEAM UHF-DualTalk offers you the possibility to communicate in a band of your
choice of two radio bands in the 70-cm-band ( UHF ). One band is the PMR band
( 446.00625 MHz – 446.09375 MHz ) and the other one the LPD band ( 433.075 MHz
– 434.775 MHz ). The TX output power is automatically matched to the allowed maxi-
mum value of the actual selected band. This is 500 mW radiated TX output power in
PMR operation and 10 mW radiated TX output power in LPD operation. The actual
selected band is indicated by the letter on the upper left corner of the main screen.
The “P” means PMR mode and the “L” means LPD mode.
If the unit receives an audible signal of a station the symbol ( E ) appears in the
lower left corner of the display.
R
9
