6
PSGR 2000 RI
USE
Before seasoning your meals, you can adjust the fineness of the ground salt and pepper
by turning the adjustment wheel on the underside of the mill.
To do so, turn the wheel clockwise for a finer grind and counterclockwise for a coarser
grind.
Turn the On
/ Off switch to the “On” position to power on the unit.
Note
: The On/Off switch doesn’t need to be turned back to the “Off” position after each
use. Leave the switch on the “On” position for a convenient and easy use of the pepper
and salt mills. Turn the
switch to the “Off” position before replacing batteries or if left
unused for a long period of time.
Hold the appliance above the meal to season. There is no button to push, grinding will
start automatically when the grinder is put upside down (gravity-activated and
automatic function).
MAINTENANCE
Clean the housing and grinding head with a damp cloth and dry with a paper towel. Do
not immerse the mill in liquid or put it in a dishwasher. Do not use with wet hands. Do not
use cleaning products or detergents.
BATTERIES
If your appliance does not work properly, it is probably because the batteries are
discharged. In that case, replace them with new ones of the same type (see “Before
use”). Please eliminate the old batteries in an environmentally fr
iendly way.
Important:
Do not mix old and new batteries
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.)
batteries
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please check that the
batteries are installed correctly and are not discharged. For best results we recommend
alkaline batteries.
If the mill gets stuck during use (motor produces hum, but internal shaft does not turn and
no pepper is ground], gently shake the mill or tap the mill gently on a hard surface, to
remove the stuck pepper or salt.
To remove deeply stuck peppercorn, remove the upper lid as if for re-filling the mill, turn
the coarseness setting to its coarsest, and tap lightly on a hard surface until all the
peppercorn is released. Re-adjust coarseness setting to the desired level once done and
replace upper lid.
Note
: Too fine a grind setting may not enable salt or pepper to be ground. If this is the
case, set the grinder to a coarser setting (see above).
