TKG GRB 1006
8
USE
•
Make sure that the reflector is well in place.
•
To reduce the emission of smoke and the temperature underneath the appliance,
you must fill the reflector with water (at least 0.5 litres) and make sure that this water
level is maintained during use.
•
Insert the heating element onto the grill casing as shown on the parts description
(insert the thermostat into the foreseen opening in the front of the grill casing and
make sure that the grill casing enters into the slot at the right side of the thermostat
and that the small metal plate enters into the grill casing; to make this happen,
slightly tilt the heating element upwards), and finally set the grill rack over it.
•
Connect the appliance and switch it on using the thermostat knob (turn the
thermostat knob to its maximal position). The pilot light will come on to indicate that
the appliance has been switched on.
•
Then preheat the grill for about 5 minutes and select the desired cooking temperature
using the thermostat knob.
•
During cooking, the pilot light will go off when the cooking temperature is reached. It
will come on when the appliance is heating again.
•
Now put the foodstuffs onto the grill rack.
•
There are 2 grill positions according to the desired cooking intensity.
•
The grilling times vary according to the ingredients and to your personal taste.
•
When grilling is finished : shut down the thermostat
(position “
0
”)
and disconnect the
appliance.
PRACTICAL HINTS
•
Frozen food should always be thawed before it is grilled.
•
When grilling big quantities, it is recommended to occasionally carefully remove the
accumulated fat from the reflector.
CLEANING AND CARE
•
Before cleaning any domestic electrical appliance, always make sure that the plug
has been removed from the mains supply socket.
•
Allow the grill to cool down thoroughly before cleaning.
•
Dismount all the accessories.
•
Pour out any remaining water.
•
Never immerse the heating element, the thermostat and the plug in water or liquid!
Wipe them with a damp cloth and dry afterwards.
•
Clean the reflector, the grill casing, the windshield and the grill rack in warm soapy
water and dry afterwards.
•
Wipe the other surfaces of the grill with a damp cloth and dry afterwards.
•
Do not use harsh abrasive cleaners.
