Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8
TKG HB 1000 - 130416
Assembly page 8/36
Fax +32 2 359 95 50
don't clean it, the air flux will progressively decrease and the appliance might get
damaged.
Make sure the hair does not come into direct contact with the air intake opening.
(*) Competent qualified electrician: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
SPECIAL ATTENTION
Your new appliance is designed with a protective coating around the heating coils. When
plugged in and operating for the first time, there may be a little momentary smoking while this
coating is initially heated. This presents no danger to the user and does not indicate a defect in
the unit. When using for the first time, allow the appliance to continue running until the smoke
dissipates. This should last only about 30 seconds.
USE
Operation
•
Always comb or brush your hair before using the appliance.
•
Use the appliance to style dry or slightly humid hair, never wet hair. Do not use it for
synthetic hair or wigs.
•
For an optimal result, use the appliance on clean and untangled hair.
•
Choose the brush you want to use. To assemble it, make sure the two indentations at the
bottom of the attachment are facing the two small lugs on the inside of the appliance,
press the release button, insert the attachment and turn it clockwise until you hear a click.
To remove the attachment, press the release button, turn the attachment anticlockwise at
the same time and pull it out.
•
Plug in the appliance and put the switch on the desired position.
0 = Off
1 = Normal
2 = Fast
COOL = Cool air function
Attachments
Small, medium and large round brush (4, 8 and 9):
•
Use the small brush if you want tight curls, use the medium brush for medium-sized curls
and the large round brush if you'd rather have larger curls.
•
Divide the hair into locks.
•
Take a lock of hair and wind it around the brush. Make sure the end of the lock is wound in
the required direction. Do not wind too much hair at a time around the brush. The thinner
the lock of hair, the tighter the curl will be.
•
Let the hot air affect on the hair for a few seconds.
Flat brush (5):
With the flat brush, you can dry your hair by doing them without styling them. You
can brush them up and down in longitudinal movements or wind them lightly around the brush.
Curling tongs (7):
•
Take a lock of hair, open the tongs by pressing the lever and place a lock between the
barrel and the clip. Release the lever and slide the barrel to the end of the lock. Then wind
the lock around the barrel in the desired direction.
•
Open the clip after 5 to 10 seconds and remove the tongs from the hair.
