Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t ch
ange the page numbering. Keep the
language integrity.
10
TKG JK 1047 - 170829
Assembly page 10/24
Fax +32 2 359 95 50
BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue left
from the manufacturing process. When the appliance has cooled down, repeat the process 3
times with fresh water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or before any operation.
•
Raise the lid and fill the tank with fresh water paying attention not to fill under the minimum
mark and above the maximum mark in the kettle.
•
Release the lid and make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and switch on. The pilot light will
come on, indicating that the appliance is operating. If it does not come on, check if the
kettle is correctly positioned on the base and check if the base is plugged in.
•
The jug kettle will switch off automatically when the water is boiling. However, you can stop
the appliance any time by putting the switch in the off-position.
•
For instant reboiling, wait until the water has cooled down and switch on the appliance
again.
•
The thermometer situated on the kettle indicates the temperature of the water in the
kettle.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device which switches the appliance
off when it is accidentally switched on without water. Please bear in mind that only the
thermostat is switched off in case of overheat, whereas the switch stays in ON-position.
•
In this case, unplug the appliance and wait about 10 minutes for the element to cool.
Then pour in sufficient cold water to cover the element.
•
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
•
Before attempting any cleaning operation, make sure the appliance is unplugged from
the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry thoroughly.
To remove scale from the inner walls of the kettle you can use a soft brush.
•
Never use abrasive products.
•
On no account must the jug kettle or its power base be immersed in water.
DESCALING
To remove scale from the jug kettle, use products made especially available for this purpose.
Make sure to use a type recommended for plastic kettles.
