Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Fax +32 2 359 95 50
Caution
: Set the temperature dial within the steam range. If the temperature setting is too low,
water may drip from the soleplate.
Check the garment label before ironing because some cloths may be damaged when
exposed to steam or water.
SPRAY
•
Produces a mist for removing stubborn creases.
•
Spray
can be used at any temperature setting and during either dry or steam pressing.
Press down the spray button to spray.
BURST OF STEAM
The burst of steam feature
provides additional steam for removing stubborn creases.
This button also allows you to iron delicate articles of clothing vertically. This feature is called
"vertical burst of steam". To do so, hang your article of clothing on a hanger, keep the steam
button pressed and pass the iron to and fro in front of the article of clothing, making sure that
the soleplate does not come into contact with the article of clothing. The distance between
the soleplate and the article of clothing depends on the kind of textile and the creases.
ANTI-CALC FEATURE
There is a decalcification box inside the appliance, which can absorb unsolvable calcium ion
and send out solvable sodium ion so that water can be softened, and the process of calcium
depositing would be much slower.
CARE AND CLEANING
•
Clean the iron regularly according to the hardness of the water and the frequency of use.
•
Fill the water tank and put the thermostat in MAX position.
•
Plug in the appliance. The pilot light will come on. Make sure the steam dial is in "0"
position. Put the iron in vertical position.
•
Never use vinegar or other liquids to descale clean the iron.
•
As soon as the pilot light goes off, hold the iron over a sink and press the clean button (8).
Steam and dust particles will come out of the soleplate.
•
When the water tank is empty, release the clean button.
•
To clean the plastic parts of the iron, use a humid cloth.
•
To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
•
Turn the temperature dial to “0” and unplug iron from electrical outlet.
•
With the soleplate facing away from you, turn the iron upside down to empty water.
•
Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
10
TKG SI 13 - 091016
Assembly page 10/40
