TKG VT 1044 RD
6
ASSEMBLY
1.
Unscrew the screws on stand A and stand B and place stand A on stand B to form an
X-base.
2.
Attach the 4 small feet onto the ends of stand A and stand B.
3.
Place the lower pipe (13) with pipe support on the X-base and fix it with the four screws
provided.
4.
Loosen and remove the pipe connector (12) from the lower pipe (13). Slide the plastic
base cover over the lower pipe on the base. Extend the upper (inner) pipe (11) and
slide the pipe connector (12) over the upper pipe onto the lower pipe and tighten.
5.
Unscrew the knurled bolt (10) but make sure that the hex nut remains attached on the
inside. Attach the motor (6) with speed regulator (8) onto the upper pipe (11) and
tighten the knurled bolt (10).
6.
Loosen the guard mounting ring (3) from the motor housing (6).
7.
Position the rear guard (4) firmly against the motor housing (6) in such a way that the
small hole for the reinforcement screw is at the bottom of the rear guard, and fasten
by turning the guard mounting ring (3) clockwise tightly.
8.
Push the blade (2) along the motor shaft (5). Fasten it firmly with the cap by turning
counter clockwise.
9.
Hang the front guard (1) to the rear guard (4) with the position fixer provided at the
front guard rim, and then clamp together with the clips provided.
10.
To ensure that it is impossible to have access to the fan blade without using a tool, a
screw is provided with this appliance in order to attach both parts of the mesh guard
together. This screw must be tightened with the appropriate hex nut on the lower part
of the guards. We will not be responsible for any injuries in case this screw had not
been tightened before using the appliance.
11.
To change the height, loosen the pipe connector (12) and slide the upper pipe to a
suitable height. Then tighten the pipe connector (12) again.
OPERATION
•
This appliance is equipped with 3 ventilation speeds. To switch on the appliance, press
one of the speed knobs.
To switch it off, press “0”.
Speed settings:
0 = OFF
1 = Low
2 = Medium
3 = High
•
This appliance also has an oscillation function:
−
Push the oscillation knob (7) to switch on the oscillation.
−
Pull the oscillation knob (7) to stop.
•
It is also possible to tilt the upper part of the appliance in order to adjust the airflow
direction vertically.
CLEANING AND CARE
•
Always disconnect the power supply cable from the power supply before carrying out
any cleaning operation.
•
To remove dirt from the plastic surfaces, use a soft damp cloth. Use a vacuum cleaner
to remove the dust from the guards without having to disassemble them.
•
Never immerse the fan in water or any other liquid.
