30
STEP G
Engine Installation
STEP G-07
q
Fuel Tube/Completed Engine Assembly
STEP G-08
q
Adjust the gear mesh between the Clutch Bell and the Spur gear
•
by sliding the engine mounts in the slots of the chassis. In order to
function properly, the Gears should be as close as possilbe, but still
have a small amount of backlash (space between the Gear teeth).
Place a piece of paper between the Clutch Bell gear and Spur gear,
•
slide the engine sideways until the paper is pinched between the
gears and tighten the engine mount screws. This will give a small
amount of space between the gears. Be sure to match the left side
engine mount parallel to the etched lines in the chassis to ensure
perfect gear mesh.
You should be able to rock one gear back and forth
•
slightly
while
holding the other one steady. Be sure to check the gear mesh all the
way around the spur gear.
Once the engine alignment and gear mesh are correct, tighten all of
•
the screws. Re-check the gear mesh after all the screws are tight to
ensure the engine mounts did not move.
LOSI-LOK
LOSI-LOK
8-32 x 1/2"
A6262
x 4
#8 Countersink
A6351
x 4
1
2
Body Clip
A8200
x 1
Supplied with
pipe
(not included)
A9315
Fuel Line
A9316
Fuel Line Clip
