Team Losi Mini HIGHroller, Operation Manual

Brake/Reverse

If the rear wheels turn during power-on, adjust the 

“TH. Trim” knob located to the lower right of the 

steering wheel until they stop.

To make the vehicle move forward, pull the trigger 

back. To reverse the vehicle, wait for the model to 

stop and then push the trigger forward. 

When going forward the vehicle should move in a 

straight line. If not, adjust the “ST. TRIM” so that it 

tracks in a straight line without having to turn the 

steering wheel. 

After you have finished, turn the Mini 

HIGHroller 

off FIRST by sliding the ESC 

switch to the “OFF” position. After the model has 

been turned off, turn off the transmitter.

If you wish to clean your Mini 

HIGHroller

, use  

compressed air and/or a soft paintbrush to remove 

dust and dirt. NEVER use chemicals or anything 

wet as it can cause damage to both electronics and 

plastic parts.

Always turn on the transmitter first. 

The small red and green lights above the switch 

should both light up. If not, you need to check for 

low or incorrectly installed batteries.

Once the transmitter has been powered on, turn on 

the Mini 

HIGHroller

 by sliding the switch on the 

ESC to the “On” position. 

ALWAYS 

•

 Turn on the transmitter before the vehicle 

• Use caution when running your vehicle near 

people 

•

 Turn both the Mini 

HIGHroller

 and transmitter 

“Off” when done 

• Check the battery condition of the transmitter 

before running

Never 

• Operate the Mini 

HIGHroller

 with

 low battery power 

• Run the Mini 

HIGHroller

 through water

 or wet grass 

• Use chemicals to clean the chassis 

• Run the Mini 

HIGHroller

 without a gear cover

STEP 4

STEP 5

STEP 6

Off

On

Off

On

TH Trim

ST Trim

Brake/Reverse

Forward

Forward

 L

ef

t

   R

i

gh

t       

 L

ef

t

   R

i

gh

t       

STEP 7

STEP 8

4