Note: Please read the entire manual to gain a full understanding of the 1/10 Night Crawler
vehicle, fine-tuning the setup and performing maintenance.
1.
Read the safety precautions found on page 3. This is important for your safety
and prevention of personal injury.
2.
Charge the battery pack you have chosen (NOT INCLUDED). Refer to the
manufacturer’s supplied instructions for battery charging information.
3.
Install the AA batteries into the Losi LSR-3000 transmitter (see page 9). Use
alkaline or rechargeable batteries only.
4.
Install the battery pack (see previous page). The battery pack should be fully
charged before installation.
5. Turn on the transmitter and then the vehicle. It is a good practice to turn on the
transmitter before the vehicle and turn it off after the vehicle has been turned off.
6.
Check steering (see page 12). Verify that the servo is functioning properly.
7.
Driving the 1/10 Night Crawler (see page 14).
8.
Performing maintenance of the 1/10 Night Crawler. Refer to Tuning, Adjusting
and Maintenance of the 1/10 Night Crawler on page 15.
Quick Start
11
