61
Apply Clear
Grease Here.
60
62
B
B
B
B
BA
A
A
A
AG E
G E
G E
G E
G E
16
Step E-2
Step E-2
Step E-2
Step E-2
Step E-2
Step E-3
Step E-3
Step E-3
Step E-3
Step E-3
1. Locate the 5/64" Allen Wrench (59) supplied with the kit. Place
the Diff Nut(57), tab side first, over the Allen Wrench.
2. Stack 12 Belleville Washers (58) over the Wrench, next to the
Diff Nut. The Washers should all point the same direction with the
concave side facing away from the Diff Nut as shown in Figure E-1B.
1. Insert all of the parts that are stacked on the wrench into the
Male Outdrive (60). Line up the tabs on the Diff Nut (57) with the slots
in the Outdrive. Press the parts all the way into the Outdrive.
1. Apply a small amount of Diff Grease (clear) (62) all the way
around the face of the outside ridge of the Outdrive(60). Attach a Diff
Ring (61) to the Outdrive by centering the hole in the Diff Ring over
the raised center of the Outdrive.
*NOTE: Only a small amount of Grease is needed, but be sure to
cover the entire face of the ridge on the Outdrive.
IMPORTANT NOTE: Do not glue the Diff Rings to the Outdrives.
Doing so may not allow the Diff Rings to mount flat.
Figure E-1B
Figure E-1A
Figure E-3
Figure E-2
Belleville washers should be stacked like this
Step E-1
Step E-1
Step E-1
Step E-1
Step E-1
61
58
57
59
Diff Nut Assembly:
Male OutDrive Assembly:
Diff Ring Assembly:
60
58
Summary of Contents for XXX-NT AD2
Page 65: ......
