BAG D (Continued)
1 6
Figure 38
!
Step 26. Insert a 3/16" x 3/8" sealed bearing (27) into the top
bearing seat of the left gearbox half (94).
!
Step 27. Insert a 1/2" x 3/4" bearing (95) into the lower
bearing seat of the left gearbox half (94).
*NOTE: If the 1/2" x 3/4" bearing only has one Teflon™ seal
(colored, woven looking) in it, position the seal to the outside of the
gearbox half.
IMPORTANT NOTE:
Never allow the gearbox halves
to come into direct contact with any type of motor spray. The
material used on these parts was selected with performance in
mind, and some motor sprays may damage the parts.
!
Step 28. Place the motor plate (96) against the outside of the
right gearbox half (97) by aligning the hole in the motor plate
(96) with the top shaft bearing housing in the right gearbox half
(97) as shown in Figure 39.
!
Step 29. Rotate the motor plate (96) so that the screw holes in the
motor plate (96) line up with the screw holes in the gearbox half (97).
Secure the motor plate (96) to the gearbox half (97) by threading a 4-
40 x 3/8" cap-head screw (17) through the hole near the center of the
gearbox half (97) — from the inside — into the hole in the motor plate
(96) and tightening.
!
Step 30. Insert a 3/16" x 3/8" sealed bearing (27) into the top
bearing seat of the right gearbox half (97). Carefully push the
bearing (27) all the way into the bearing seat using a pencil or
the handle of a hobby knife. Care should be taken not to dam-
age the seals on the bearing (27).
*NOTE: If the 3/16" x 3/8" bearing only has one Teflon™ seal
(colored, woven looking) in it, position the seal to the outside of the
gearbox half.
!
Step 31. Insert a 1/2" x 3/4" bearing (95) into the lower
bearing seat of the right gearbox half (97).
!
Step 32. Press, and lightly tap, the idler gear shaft (98), into
the hole in the center of the right gearbox half (97).
Figure 39
Figure 39
27
95
17
27
95
98
Figure 38
95
94
27
97
98
95
27
96
17
Summary of Contents for XXX-T Matt Francis Edition
Page 2: ......
