TEAM TEX D9, Manual

30

EN

 - User guide

Thank you for purchasing this 

Group 0-1-2 car seat

. If you require assistance with this prod-

uct or if you wish to change an accessory, please contact our 

customer service department

.

SAFETY INSTRUCTIONS

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE BEGINNING THE INSTALLATION. IF 
THE SEAT IS NOT INSTALLED CORRECTLY, YOUR CHILD’S SAFETY MAY BE AT RISK. 

DO NOT 

USE THIS CHILD SEAT ON A PASSENGER SEAT FITTED WITH AN AIR BAG!

 The seat may be 

installed in a front-facing or rear-facing position with a 3-point safety belt to UN/ECE No.16 
standard or equivalent. Do not use it on side-facing or rear-facing seats. Always remember to 
fasten and correctly adjust the child’s harness and never start the car without first checking 
that the seat is properly fixed to the passenger seat as shown in these instructions. Do not use 
weight-bearing contact points other than those described in the instructions and indicated on 
the restraint system. It is important to check that the straps of the seat belt are fully tightened 
and that the harness lap strap is positioned as low as possible to support your child’s pelvis. 
Check that the seat belt and harness straps are not twisted. For maximum protection, there 
must be no slack between the car seat and the passenger seat. Please refer to the method rec-
ommended in these instructions. The seat must not be modified in any way and no elements 
should be added. It is recommended that you replace this car seat if it has been subjected to 
a severe impact following an accident or in case of wear. You should regularly check that the 
harness is not showing signs of wear; check in particular the harness points, the seams and 
the adjustment devices. Never leave your child unattended in the seat. Check that no part of 
the seat is trapped in the door or in a fold-down passenger seat. If your car has a fold-down 
rear seat, check that it is correctly locked in the vertical position. Direct exposure to the sun 
increases the temperature inside vehicles. For this reason, you are advised to cover the child’s 
car seat when not in use in order to prevent the elements, in particular the fixations, from 
getting hot and burning the child. Do not use your car seat without its cover and only replace 
it with a cover that has been recommended by the manufacturer. In an emergency, the child 
must be able to be freed quickly. The buckle, which can be easily opened, must therefore not 
be covered. Teach your child not to play with the buckle. Always remember to check that there 
are no scraps of food or other remains in either the harness buckle or the central adjuster. 
Luggage and other heavy or sharp objects must be fixed down in the car. Objects that are not 
attached may injure a child in the event of an accident. In winter, make sure that the child is 
not wearing over-bulky clothes.

Your Group 0-1-2 car seat 

(1)

This seat is classified as group 0-1-2 for children from 0 to 25 kg.
1. 

Shell + cover

2.

 H shoulder pad 

(x2)

3.

 Adjuster 

(x2)

4.

 Adjustment strap 

(x2)

5.

 Harness buckle

6.

 Base

7. 

Blue lock-off clip 

(for rearward facing use only)

8.

 Infant reducer cushion 

(some models only)

9. 

Pillow 

(some models only)

10. 

Diagonal belt guides 

(x2 - for rearward facing use only)

11.

 Red belt lock-off 

(x2 - for diagonal belt (forward facing use only)

12. 

Lap belt guides 

(x2 - for forward facing use only)