4. Use
4.1 Positioning in the vehicle
This child safety seat is suitable for use with
3
-point safety belts certified according to the
UN/ECE regulation No.16 or other
equivalent standard.
Not suitable for use with 2-point safety belts.
Remark: We recommend that you lock the
seat’s ISOFIX clips onto the vehicle’s
ISOFIX attachments for increased safety.
Recommended positions
Positions not recommended
Only use this position if the
vehicle’s seat is equipped with
ISOFIX attachments.
4.2 Adjusting the height of the headrest
The headrest has 11 different
positions to best adjust to your child’s
size. Adjust the headrest to the
appropriate height by operating the
adjustment lever to move the
headrest up or down (as shown
opposite).
Important: once the headrest has
been adjusted to suit your child’s size,
make sure that it is properly locked
into position.
ISOFIX clips
Headrest adjustment lever
4.3 Adjusting the height of the harness
Make sure that the height of the shoulder straps is adjusted to suit your child: the straps
should be adjusted just slightly above the child’s shoulders (the correct adjustment is
indicated above).
The height of the harness for this product is adjusted by moving the headrest. Adjust the
height of the headrest in order to adjust the harness to the appropriate height.
4.4 Buckling the harness
Step 1: Gather the ends of the shoulder
straps.
Step 2: Insert them into the buckle, you should hear them click into place. Check that the
harness is properly fastened in the buckle.
Step 3: To unfasten the harness, press the red button in the middle of the buckle.
4.5 Adjusting the harness
1. Tightening the harness:
Pull the harness adjuster strap until the harness is tight enough. Tighten the harness as
much as possible without causing discomfort to the child. The lap belt is as low as
possible and should be closer to the crotch rather than the abdomen.
A badly adjusted harness can be dangerous for the child. Each time the child is installed
in the child safety seat, buckle the harness then tighten it using the adjuster strap. Make
sure it is properly tightened and that none of the straps are twisted (
illustration 1
opposite).
TOO LOW
TOO HIGH
CORRECT
Step 1
Step 2
Step 3
24
25
EN
Summary of Contents for SEATY 360
