6. Removing the seat cover
1)
Remove the shoulder harness and the sheaths (see point 5.4).
2)
Unfasten the buckle and remove the buckle protection and the reducer (see point 5.4
and illustration 1 on the next page).
3) Undo the press studs and remove the seat cover (see illustration on next page).
Remark: to replace the seat cover, repeat these operations in reverse order.
Reducer and
buckle
protection
Remove
through
slot in
seat’s shell
Remove the plastic cover
Shoulder
harness
tidied
under the
cover
7. Maintenance and cleaning
7.1 Regular maintenance
1.
Regularly check the child safety seat’s
condition and state of wear & tear. In the event of
an accident, the seat must be replaced.
2. When not in use, store the child safety seat in a dry and ventilated place to avoid
humidity and mold.
3.
Clean dust from the surface of the child safety seat, the harness and plastic elements
with a damp sponge and allow to dry in the fresh air.
4. If the harness is soiled by food or drink, remove it and rinse it in warm water then allow to
dry in the fresh air.
5. If you wish to clean the child safety seat cover, please refer to the washing instructions.
7.2 Washing instructions
Solvents, chemical cleaners and lubricants are not to be used on any part of this product.
34
35
EN
Summary of Contents for SEATY 360
