Run the rear brake cable in its sheath and install to
the left brake lever and tighten to the desired
tightness. Take this opportunity to check alignment
and tightness of the rotor.
Install the gear cable and tighten. Remember to
adjust the high and low maximum/minimum
positions.
Use a 15mm spanner to install the pedals. These
come in a left right pair – make sure to get these
around the right way. R/L is written on the end of bolt
thread.
Mount the rear reflectors to the rear mudguards.
Mount the mudguard mounts to the rear mudguards.
Use the 8 remaining 10mm hex head bolts to mount
the rear mudguards.
