An easy way to stop the rear section from moving around
while trying to attach is to support rear section with foam
block or box etc
MOST IMPORTANT:
When fitting 4 main frame bolts
plus A-Frame bolts lubricate threads with
“Dry-Lube”
or
grease
Do not tighten these 4 main bolts at this time.
IMPORTANT NOTE
: When fitting 4 main frame bolts and
A-Frame bolts – heads to front of tricycle then flat washer
– nut to rear of frame with flat then Nylock nuts
Now attach the A Shaped Stabilizer arm, Tighten top bolt
to seat tube as shown and 2 bolts attaching to rear
section of frame.
It’s important to tighten the A-Frame before the 4 centre
bolts as this ensures the front section and rear section
line up perfectly.
Now tighten the 4 centre bolts.
Once the two sections are securely joined, it’s a good
time to secure power supply cable to underside rear
frame using frame guides and zip ties supplied.
Fit the front section chain, and check the tension of both
chains. You may need to adjust the transfer axle to
achieve this.
