7
TEC-67398-2
Technical description Prizrak-5S BT
Testing
the detection quality of tags
Perform this procedure when the engine is running. It is recommended to slightly increase and decrease the
engine’s RPM while testing the tags.
Testing procedure:
1.
Complete authentication. The immobilizer will emit the confirmatory trill indicating that the authentication
is successful.
2.
Press and release the programming button 12 times, the immobilizer’s buzzer will emit 4 short beeps.
3.
Press and release the programming button 11 times, the buzzer will emit 1 long and 1 short beep to indicate
that the option №11 of the programming menu has been successfully selected.
4.
Press and release the brake pedal during 10 seconds until a sonic signal is sounded. Release the brake
pedal, the immobilizer will turn on the constant tag search mode.
5.
Verify the tag detection quality by moving the tag to different places within the vehicle’s interior. The
confirmatory trill emitted every 3 seconds indicates the reliable tag detection.
6.
To exit the option «Testing detection quality of tags» press the brake pedal or simply turn OFF the ignition.
Authentication
Authentication
Authentication is a procedure of verifying whether the driver is authorized to drive the vehicle
or not. Every time prior to driving, the authorized vehicle driver should have a special tag within the vehicle and/or
enter a secret PIN code combination using the dash buttons, or steering wheel buttons of the vehicle. The authenti
-
cation is carried out either after turning the ignition ON or after starting the engine. The confirmatory trill will sound
if the authenti cation is successful. A smartphone may be used for authentication instead of a Slim tag.
A preferred authentication method can be easily set during the installation process without having to enter a
secret PUK code. As soon as the vehicle has travelled 10 km after installing the system, the authentication method
can only be changed after entering the secret PUK code located on the plastic card supplied with the device.
Futhermore, a long warning beep will sound every time after completing the authentication if duaring installation
of the system the authentication method has been changed to «PIN code or tag». To disable the long warning beep,
enter PIN code to confirm that you are familiar with it and are able to use it when needed.
Table 1. Authentication methods
Authentication method
Authentication procedure description
Tag
(factory value for Prizrak-5S/BT/Slim and
Prizrak-5S/BT/2Slim)
A tag must be in range
Wait for confirmatory trill
PIN code
*
Enter PIN code
Tag or PIN code
(factory values for Prizrak 5S/BT)
Tag must be in range
If a tag is absent —
you may enter PIN code
Tag and PIN code
(two-factor protection)
Tag must be in range and PIN
code must be entered
There must be two
confirmatory trills
*
The authentication method «PIN code» is helpful in case if it is necessary to exclude the possibility of using the tags (e.g. when they are stolen
or lost) until new tags are purchased and registered.
If the authentication method is «Tag and PIN code» it is required to deactivate both security contours (wait
until the tag is detected and enter PIN code). It will not be possible to drive a vehicle if at least one of the security
contours is not deactivated.
Additional warning beeps (besides the confirmatory trill) followed after the authentication procedure mean that
it is necessary to take particular actions.
Table 2. Warning beeps after authenticaton
Warning beep Reason
Recommended actions
Long
The default PIN code hasn’t been changed Change the default PIN code
Serfvice/Valet mode is enabled
Deactivate the Valet/service mode off
The authentication method «Tag» has
been changed to «Tag or PIN code»
Enter PIN code (to confirm that the authentica tion
method was changed under your will)
Five short
It is required to replace the
tag battery
Replace the tag battery for a new one
