6
TEC-61231-23 Technical Manualе
PRIZRAK
RFID tag
RFID tag
is an electronic key that must be with the driver at all times during the vehicle operation. Before the vehicle starts moving, the
system will automatically identify the RFID tag and deactivate all security functions. When the RFID tag is identified, the system will emit a trill.
Battery replacement
If the battery needs to be replaced, the system will trigger 5 short audio signals after the RFID tag is identified. The battery type for the
RFID tag is CR 2025. To replace it, contact the system installer or do it yourself.
If the ambient temperature is below zero, batteries can perform worse due to slower rate of chemical reaction. It can make identification
of the RFID tag more difficult, especially if it was exposed to low temperature environment for a long time. To restore performance
of the battery just warm up the RFID tag.
Dual authentication
Authentication
locates and identifies the RFID tag and/or entered PIN code. This procedure is carried out when the ignition is on or the
engine is started. After successful verification, LED will be switched off and a trill is emitted.
Table 2. Methods of authentication
Method of authentication
Verification procedure
RFID tag (factory default)
RFID tag is with you
Wait for a trill.
LED will go out
PIN code*
Enter PIN code
RFID tag or PIN code
RFID tag is with you
RFID tag is not available. Enter PIN code
RFID tag and PIN code
(dual authenication)
RFID tag is with you. Enter PIN code
Wait for two trills.
LED will go out.
If you use the RFID tag and PIN code authentication, both security circuits have to be deactivated before the vehicle starts moving.
If one or more circuits are still active (i.e. there is no RFID tag, or PIN code is not entered), the vehicle will not move.
Authentication method can be selected when installing the Alarm without using the PUK code. As a result, the PUK code remains
secret.
Authentication method can be changed without using the PUK code if:
•
The vehicle did not travel more than 10 km after the Alarm was installed (the Speed control is available)
•
The ignition was not active for more than 20 minutes after the Alarm was installed (the Speed control is not available).
If during the installation the verification method was switched to "RFID tag or PIN code" after the vehicle was driven for 10 kilometers (if the
Speed control is unavailable: after the ignition was on for 20 minutes) at the end of each verification an alarm signal will sound. It will inform
that verification method was changed. To deactivate the signal, enter the PIN code.
Quick engaging of the second circuit for high risk locations
The RFID tag authentication is very easy to use. In most cases this
verification method is enough to protect the vehicle. However, when
leaving the vehicle in high risk locations (for example, at public parking
lots) you can provide maximum hijack protection by engaging second
circuit for one security cycle. Authentification method can be quickly
changed from "RFID tag or PIN code" to "RFID tag and PIN code"
without need to use the settings menu.
To quickly engage maximum security:
•
Turn on the ignition
•
Wait for RFID identification
In
the next 10 seconds:
•
Open and then close the driver’s door
•
Enter the PIN code, wait for confirmation
•
Turn off the ignition
•
Wait for two trills which mean that "RFID tag and PIN code"
verification method is activated.
To easily open the tag, you can
use an edge of a plastic card
Use only high quality non-
expired batteries!
Open here
Carefully
observe the
polarity
3V
CR 2025
