5235
TECSource
User’s Manual · Page 25
Maintenance and Service, and Calibration
Maintenance
The
TECSource
requires no regular maintenance other than product calibration.
To clean the instrument, use cotton cloth that is only damp (not wet) with a light
solution of soap and water.
Fuses
Under normal operation, you should never need to replace a fuse. However, if
either fuse does blow, use only T 250V, 1.0A, IEC 60127-2 5x20mm metric fuses
as replacements.
If, after replacing the fuse, it continues to blow, immediately discontinue use of
the instrument and contact service for support.
Service
Service and repair for the
TECSource
can be obtained by contacting the
distributor from where you purchased the instrument, or directly from Arroyo
Instruments. A complete list of distributors is available on the Arroyo web site.
You can contact Arroyo Instruments through one of these methods:
By mail:
Arroyo Instruments
373 Front Street, Suite B
Grover Beach, CA 93433
USA
By phone:
+1 (805) 481-6684
By fax:
+1 (805) 481-6628
By email:
support@arroyoinstruments.com
On the web:
http://www.arroyoinstruments.com
In all cases, Arroyo Instruments requires a return materials authorization (RMA)
number. You must contact Arroyo Instruments and obtain an RMA number prior
to returning your instrument, or the shipment may be rejected and sent back to
you.
Summary of Contents for Arroyo 5235
Page 1: ......
Page 26: ...Page 26 5235 TECSource User s Manual Notes...
