18
The LCD Display
Display
Function
Display
Function
Input Information
Output Information
It indicates input
voltage/frequency value, which
are displayed alternately.
It indicates output
voltage/frequency value, which
are displayed alternately.
It indicates the input is
connected with mains, and the
input power is supplied from
the mains.
It indicates the Output plug.
It indicates the Number of the
input supplied from the mains.
It indicates the Number of the
output connected with load.
Battery Information
Load Information
It indicates the battery capacity.
Every grid represents the
capacity of 20%.
It indicates the load level. Every
grid represents the level of
20%.
Mode/Fault/Warning Information
Else
It indicates the UPS is in setting
mode.
It Indicates the operating mode
or Fault kind or Warning kind,
several warning kinds at the
same time could be displayed
alternately.
It indicates the UPS is in Fault
mode or has some warnings.
19
5. Connection and Operation
5.1 Inspection:
Inspect the packaging carton and its contents for damage. Please inform the
transport agency immediately should you find signs of damage.
Please keep the packaging in a safe place for future use.
Note: Please ensure that the incoming feeder is isolated and secured to
prevent it from being switched back on again.
5.2 Connection:
(1) UPS Input Connection
If the UPS is connected via the power cord, please use a proper socket with
protection against electric current, the user can refer to below table. If the
UPS is connected via wires, it is recommended to select the 2.5mm
2
wire,
and the “GND” terminal should be grounded first.
The UPS System has no input breaker on the standard cabinet. When
installing the UPS, the user needs to connect the external breakers and
protective components in the input terminals. It is recommended to select the
NFB(Non-Fuse Breaker) instead of the traditional combination kit including
breaker and fuse.
When selecting the NFB, the user can refer to below table.
UPS INPUT NFB & Power Cord & Socket
Model No.
VOLTAGE
CURRENT
1K & 1K-KS
300Vac
10A
2K & 1K-KS
300Vac
16A
3K & 1K-KS
300Vac
20A
The system may be installed and wired only by qualified electricians
in accordance with applicable safety regulations!
When installing the electrical wiring, please note the nominal
amperage of your incoming feeder.
