2-8
2. MAJOR UNIT REPLACEMENT
EM18-33011
2.6 Replacing the Print Head
CAUTION:
1. NEVER touch the element when handling the print head.
2. NEVER touch the connector pins to avoid a breakdown of the print head by static electricity.
3. NEVER remove the two screws painted red on the side of the print block.
4. NEVER remove the four screws on the side of the printer block.
5. NEVER remove the print block, otherwise it requires the adjustment of the position when
reassembling.
NOTE:
The following procedure can be employed without removing the top cover and the left side
cover.
2.6.1 Old type print head
1) Turn the head lever clockwise to lower the print head. Remove the two SM-4x8B screws.
2) Turn the head lever counter clockwise and disconnect the two connectors to detach the print
head from the print block.
(Revision Date: Feb. 01 '96)
2.6 Replacing the Print Head
3) Replace the print head, connect the connectors and install it in the print block.
4) Turn the head lever clockwise. Push the print head and secure it temporarily.
Follow the procedure on the next page.
Fig. 2-13
Print Block
Head Lever
Connector
Print Head
Screw (SM-4x8B)
Connector
Screws painted red
(NEVER remove these screws.)
Screws
(NEVER remove these screws.)
