6-28
6. DIAG. TEST OPERATION
EO18-33007
6.3.7
Font Zero Selection
6.3 PARAMETER SETTING MODE
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
2. A changed zero font is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
Press the [FEED] key.
Press the [PAUSE] key 8 times.
Select either zero font with the
[FEED] key or [RESTART]
key. (See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
Press the [PAUSE] key .
Continued on Section 6.3.8
Baud Rate Selection
0 (without slash)
0 (with slash)
< 1
D I A G N O S T I C V
>
1 . 0 A
Z E
O F O N T
R
0
< 2
P A R A M E T E R S E T
>
Summary of Contents for B-880 series
